Published with Blogger-droid v1.6.9
Wednesday, May 18, 2011
Fwd: [MakerBot] Question about Thermocouple installation into Gen3 extruder
---------- Forwarded message ----------
From: Zip Zap <zzap999@yahoo.com>
Date: Wed, May 18, 2011 at 1:40 AM
Subject: [MakerBot] Question about Thermocouple installation into Gen3 extruder
To: makerbot@googlegroups.com
--
You received this message because you are subscribed to the Google Groups "MakerBot Operators" group.
To post to this group, send email to makerbot@googlegroups.com.
To unsubscribe from this group, send email to makerbot+unsubscribe@googlegroups.com.
For more options, visit this group at http://groups.google.com/group/makerbot?hl=en.
From: Zip Zap <zzap999@yahoo.com>
Date: Wed, May 18, 2011 at 1:40 AM
Subject: [MakerBot] Question about Thermocouple installation into Gen3 extruder
To: makerbot@googlegroups.com
I want to know where you would install the thermocouple into the extruder board for the MK5. Is it the same terminal location for the thermistor? Also, will I have to upload additional code to the firmware as described in
http://www.reprap.org/wiki/Thermocouple_Sensor_1_0 for uploading to the Arduino board?
http://www.reprap.org/wiki/Thermocouple_Sensor_1_0 for uploading to the Arduino board?
You received this message because you are subscribed to the Google Groups "MakerBot Operators" group.
To post to this group, send email to makerbot@googlegroups.com.
To unsubscribe from this group, send email to makerbot+unsubscribe@googlegroups.com.
For more options, visit this group at http://groups.google.com/group/makerbot?hl=en.
--
http://www.google.com/profiles/technologiclee
Subscribe to:
Posts (Atom)
Posts
